CLEANING

WARNING

• To reduce the risk of electrical shock, DO NOT clean the hood while it's operating.
• Never put your hands into the area housing the fan when the fan is operating.

Cleaning the Exterior Surfaces:

IMPORTANT

To avoid damage to the exterior surfaces:

• DO NOT use corrosive or abrasive detergent.
• DO NOT use steel wool, scoring pad or steel brushes. Use a paper towel or soft cloth or nonabrasive sponge instead.
• DO NOT use salt solutions, disinfectants, bleaches or cleaning compound that contains harmful chemicals.

Cleaning Method:

• Noncorrosive or nonabrasive liquid detergent soap or all-purpose liquid cleanser.
• Wipe the surfaces with a damp paper towel or soft cloth or nonabrasive sponge.
• Rinse with clean water.
• Wipe dry with dry towel or cloth.

Note

• The nonabrasive stainless steel polisher can be applied when done cleaning to retain the stainless luster and grain.
• Always follow the instruction of the polisher.

Cleaning the Stainless Steel Baffle Filters:

• Pull the spring release handle and remove the filter by pulling it down.
• Wash the filters in the dishwasher, or soak it into hot or warm water with dish detergent for half an hour, then wipe the filter clean. Repeat these steps until there's no oil residue remains.
• Let the filters dry thoroughly.
• Make sure the spring release handle is toward the front, align and insert the filter.
• Pull the spring release handle and push the filter into position.
• Release the handle.
• Repeat the steps for the remaining filters.

Cleaning the Oil Collector:

• Hold the oil collector at both ends and slide it toward the user to detach it from the hood body. Do this in reverse to install the oil collector back to the slot after it's been cleaned and dried completely.
• Wash the oil collector in the dishwasher, or soak it into hot or warm water with dish detergent for half an hour, then wipe the filter clean. Repeat these steps until there's no oil residue remains.
• Wipe off the excess water from the oil collector and put it in a safe location to let it dry completely.

REPLACING THE FILTERS

• Replace the baffle filters immediately should they become worn out due to aging or prolonged usage.

REPLACING THE LED LAMPS

WARNING

• Electrical Shock Hazard
• Disconnect power before servicing
• Wear gloves to protect against sharp edges

• This range hood uses 12V, 2W LED. Contact Awoco customer service to get the replacement LED lights.
• Unplug the range hood, or turn off the breaker.
• Remove the Baffle Filter adjacent to the Lamp.
• Reach into the Hood Unit and push the Lamp out from the inside of the Hood Unit.
• Disconnect the wires.
• Connect the wires to the new Lamp.
• Align and put the new Lamp back into position.
• Press the edge of the new Lamp until it touches the bottom of the Hood Unit.
• Put the Baffle Filter back into place.
• Plug in the range hood, or turn on the breaker.
• Check if the new Lamp is working properly.